Small / Not too deep/wide shelf and closet rod bracket? - closet rod extenders
My staff takes too much class and so close every time the doors to reach the stirrups.
On the wall below the platform is a long piece of cardboard is on the horizontal platform support. Below the horizontal center line of wood, a small piece of wood vertically. The two pieces of wood are the same depth. In these 2 pieces of wood support: To get a better idea of what I mean, please take a look at this site: http://www.johnsterling.com/shelfrodbrackets.htm and see photo 5 ° for the Model No. 0043 left - which is the horizontal board, behind the support that goes diagonally, is the advice that comes from the vertical.
I've heard that I know will not remove the doubling of the current, support the timber horizontally and vertically, or a hole in the forest, further, I do not whether it could stand a stallion.
Carpenter advised to get a 9 "deep support, but I find10. See model 0042 adjustable particular site.
Thursday, November 5, 2009
Closet Rod Extenders Small / Not Too Deep/wide Shelf And Closet Rod Bracket?
Subscribe to:
Post Comments (Atom)
4 comments:
You can make your own stand with a piece of 1 X 6 30 "long
Cut a piece of 9 1 / 2 "long
Removing Media
The 9 1 / 2 "piece replaces the support
To initiate and to support the Temporary brand that you want the crossbar.
Mark where the board is mounted horizontally on the wall.
Take it down and drill cut a hole big enough to walk through the bar.
Mark the center of another room.
Nail the other piece in the middle of the back 9 1 / 2 "piece to the hole just below the plaque on the wall.
Line up the 9 1 / 2 "Hound was on board when the nails and the other piece of the wall to the studs.
Good Luck
It is very likely that a standard and that there, where they threw the support of business first. The only way to know for sure whether is a standard drill there and observe.
A South from the bottom up, then just below the drill collar / plate and see what he hit. It seems that the easiest way to bend the rack, or another medium, which would have to fold
I have experience with this kind of media company. Believe me, you do not want the nail right on the wall, if there is a hole. Realized and break the wall. Depending on the level of model fitting is adjustable, so it seems. This is the best information I have.
I have experience with this kind of media company. Believe me, you do not want the nail right on the wall, if there is a hole. Realized and break the wall. Depending on the level of model fitting is adjustable, so it seems. This is the best information I have.
Post a Comment